Steuerkopflager Kit Honda

Artikelnummer: 22-1011

Lenksäulen Lager und Dichtungs Kit Honda

Kategorie: Lenkkopflagerkits


50,34 €

inkl. 19% USt. , zzgl. Versand (Hermes Standard)

sofort verfügbar

Lieferzeit: 2 - 3 Tage



Steering Brg - Seal Kit Honda CB350 68-73, CB350 F-F1 72-74, CB360 74-77, CB400A 78, CB400F 75-77, CB400T 78-81, CB450K1-K2 68-69, CB450K3-K7 70-74, CB450SC 82-86, CB450T 65-82, CB500 71-76, CB500T 75-76, CB550F 75-77, CB550K 74-78, CB550SC 83, CB650 79-85, CB750A 76-78, CB750F Super Sport 75-78, CB750K1-K5 750 Four 69-78, CJ360T 76-77, CL350 Scrambler 68-73, CL360 Scrambler K-K1 74-75, CL450 Scrambler K-K6 69-72, CM400 79-81, CM450A 82-83, CM450C 82, CM450E 82-83, CN250 87-07, CX500 78-79, CX500C 79-82, CX500D 79-81, CX650 83, FT500 Ascot 82-83, GB500 89-90, GL1000 Gold Wing 75-76, GL1000L 76, GL500 Silver Wing 81-82, GL650 83, SL350 70-72, VT125 SHADOW (Euro) 99-06, VT500C 83-84, VT500FT 83-84, VT700 84-85, VT750 83, VTR250 Interceptor 88, XL125 V VARADERO (Euro) 01-11

This kit (22-1011) contains 2 washers.

One of the washers may be required in some applications. To

determine whether and which washer is required, the total height of the original lower bearing stack must
be measured.
Take the 2 old bottom races (one from the lower frame and one from the lower triple tree) and place the
balls into the races. Compare the total thickness (stack height) of the original bearing set to the total
height of the taper bearing replacem ent set. If the thickness of the original bearing set is within +/- 1mm
of the taper bearing replacement, discard the washers. If the thickness of the original bearing set is
greater than 1mm, use the appropriate spacer washer to bring the total height of the taper bearing
replacement set to within 1mm.